AgTalk Home
AgTalk Home
Search Forums | Classifieds (161) | Skins | Language
You are logged in as a guest. ( logon | register )

Maximum driveline angle for shop built project
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
wannabe2
Posted 1/25/2025 12:18 (#11073082 - in reply to #11073029)
Subject: RE: Maximum driveline angle for shop built project


NW Montana		The angle of the output shaft needs to match the pinion
Your offset angle will determine if you need cv joints or if you can use u joints.

Get your angles set then call a driveline shop.
They make wedges to change the pinion angle

9” rise over a 29” run is doable with u joints but u need to match up the in and out shafts first.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)