roaming | baldy50 - 10/6/2024 19:56
Our pro 700 in a case 2388 combine says there is no operator in the seat. When you raise out of the seat the header will disengage. So figure the seat switch is working. Is there a screen to turn off that operator presence or a way to jump the harness so the 700 will think someone is in the seat.
Thanks
Go to Toolbox > Display Setup. What vehicle software is listed in the lower right corner?
Are you running autoguidance? That's the only reason the display should care if there's someone in the seat, on a 2388. The rest of the machine isn't tied into the display like it is on newer machines. |
pro 700 operator Presence
